New for 2012. NOW COMES WITH YOUR CHOICE OF LANDING GEAR; TRICYCLE AND TAIL DRAGGER. IT'S ALL IN THE BOX.
OVER SIZE AND DOUBLE BOXED- 49X18X10 BOX SIZE
WE HAVE THIS PLANE IN ALL 3 COLORS THAT ARE LISTED FOR STICK AIRPLANES.
New item for 2011. (OVER SIZE SHIPPING AND DOUBLE BOXED) We have the factory double box (or crate) our planes and they do an over-kill which makes the fgt. higher because of box size. But who want a busted plane and try to collect from the fgt. carrier?
This is an ARF and not a kit. Comes with complete hardware kit that includes- 2 1/2" foam wheels' fuel tank alum. landing gear that attaches with 4 screws, spinner, push rods, tail wheel, etc.
Details are as follows:
Fuselage- Lite ply construction with lighting holes to save weight, Servo tray is installed and is located under the wing (1 servo for throttle, 1 servo for rudder).For elevator servo look at the tail feather section. Firewall measures 4" wide and 4" tall. Landing gear attaches 5 3/4" back from firewall and uses 3 screws. Fuselage has a hatch located between wing and firewall with a spring loaded latch that lets you service the fuel tank (or batteries if you are using electric power)
Wing- 2 1/4 inches thick, 15 1/2" cord, symmetrical design, built up balsa design. has hardwood joiner and the 2 halves epoxy together. Uses 2 aileron servos for the ailerons (1 under each wing half). Ailerons are 22" by 3 1/2".
Tail Feathers - 8 1/2" cord including elevator halves. Horizontal stab. is 20 1/4" on leading edge tapering to 25" at rear (with elevator halves installed). Elevator halves are 9 1/2" by 3 3/4" each and are functioned by a single servo with dual wires attaching to each half. Vertical stab. is 8 3/4" tall and 8 1/2" long tapering to 2 1/2 inches at the top (rudder not included). Rudder is 8 1/2" tall. Rudder is 4 1/4 inches at the bottom tapering to 2 1/4 inches at the top. Elevator functions with 2 horns installed on the elevators (1 horn for each half) and 2 push rods that join together at the elevator servo. ( single elevator servo with 2 push rods)
email from customer- Robert, I received the Drastik in four days. No damage. Was concerned about the no-name iron on covering, but it seems fine and had far less wrinkles than the Monocote and Ultracote covered Arfs I've done previously. I am especially impressed with the hinging cutouts for the control surfaces. A quick slice with an exacto knife (mostly to locate the slits) and the hinges go in easily yet fairly firmly. Almost finished. If it flies as well as it assembles I'll be very happy with it. Feel free to use this reaction as a review/testimonial if you want.
Wingspan: 66.1 inches
Wing Area: 973.6 sq. in.
Length: 59.7 inches
Engine: 2C 0.60-0.75 cu.in (not included)
Requires radio with 4 channels and 5 servos (not included)