All wood construction, fiberglass fuselage, excelent hardware kit, up graded 4 1/2" rubber tires with premium axles, pre-install hatch and canopy (no cutting out), fuel tank, push rods, but you have to furnish your spinner and epoxy.
Cowl is 9 1/2" deep/ 9 1/2" wide / 10" tall and when installed it measures 7" from the motor box to the front opening where the prop washer should be.
Motor Box is fuel proffed and has extra triangle stock installed. Measures 4" tall and 7" wide and crounstructed with plywood.
Leading part is sheeted solid with balsa while the elevator part is built up and covered. Looking ar the plane, it seems to give you 2 options for mounting the servos. The horizonal stabs have doors in the bottom to mount the servos inside them, and the fuselage has places to mount the elevator servos in the sides of the fuselage. Two places for servos on the right side of fuselage (top one for the rudder servo and lower for elevator if you decide to use this option. Elevator uses the robart style hinges and the horzional stab. joins to the fuselage with an alum. tube and attaches with 4 screws to the pre-installed blind nuts. If you mount the servos inside the horzional stab., it would be very eazy to remove and transport.
Vertical stab and rudder---
Vertical stab. is sheeted solid, while the rudder is built up and covered. The servo mounts on the right side of the fuselage. But looking inside the plane there is a place for a rudder servo and pre-installed tubes that could be used as a pull-pull system if you desire.
Big 110" wing span with 5 inches of the leading edge sheeted with balsa and the rest covered with oracover. Wing tips are fiberglass and turned down. Pre installed wing tip lights. The aileron servos are hidden inside the wing with only the servo arm sticking out to attach the control rod. The flap servo is really a neat and clean design. The servo is hidden inside the wing and nothing hangs out the wing (it hooks up inside the wing and is hidden. I took a photo and it shows the flap control arm.
FUSELAGE--- Excelent construction and sturdy. Built of light ply. with enought lighting holes to keep it light but still strong and the covering job is excelent. Hatch is very large and has quick access.
Wingarea: 108 dm2
Engine: 50-80cc gas engine
Radio: 5 Channel;8 Servos
TOP OF HORIZONAL SRAB. WITH ELEVATOR AND TUBE INSTALLED (AIR FOIL DESIGN)
BELOW IS BOTTOM OF HORIZONAL STAB SHOWING SERVO MOUNTING
NOTE THE BEAUTIFUL COVERING JOB
PLENTY OF ROOM UNDER THE HATCH. HATCH AND CANOPY ARE PRE-INSTALLED
BELOW IS THE FLAP IN ITS LOWEST POSITION TO SHOW CONTROL ARM THAT IS HIDDEN INSIDE WING WHEN SERVO IS INSTALLED.